UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            1
                        
                            Page
                            10219
                        
                            Issued:1994-07-14
                    
                            Revised:2012-03-30
                    
                            Style
                            10219
                        
                            Single or Multiple-Conductor Cable with Extruded Non-Integral Jacket
                    
			Rating60 deg C, 30 Vac, Horizontal flame.
		
			InsulationLabeled or complying with Manufacturer's AWM.
		
			AssemblyConsists of one insulated conductor and jacket. If signal wires are provided, they are twisted around main conductor. The lay is not specified. A barrier layer and/or fillers are optional. Manufacturer shall maintain a complete description of each assembly. May use same or mixed AWG size.
		
			Signal WireOptional - 5 V maximum, labeled or complying with Manufacturer's AWM Procedure
		
			ShieldOptional.
		
			CoveringOptional. Extruded PVC, 6 mils minimum thickness or PETP tape, 1 mil minimum thickness, may be applied over the conductor assembly.
		
			JacketExtruded PVC, 15 mils minimum average thickness, 12 mils minimum thickness at any point.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseProbe Cable for use with instruments where shield (if provided) is grounded.
		
                UL and the UL Logo are trademarks of UL LLC © 2025

Subj.758	Section 1	Page 10219	Issued:1994-07-14
			Revised:2012-03-30


Rating	60 deg C, 30 Vac, Horizontal flame.

Insulation	Labeled or complying with Manufacturer's AWM.

Assembly	Consists of one insulated conductor and jacket. If signal wires are provided, they are twisted around main conductor. The lay is not specified. A barrier layer and/or fillers are optional. Manufacturer shall maintain a complete description of each assembly. May use same or mixed AWG size.

Signal Wire	Optional - 5 V maximum, labeled or complying with Manufacturer's AWM Procedure

Shield	Optional.

Covering	Optional. Extruded PVC, 6 mils minimum thickness or PETP tape, 1 mil minimum thickness, may be applied over the conductor assembly.

Jacket	Extruded PVC, 15 mils minimum average thickness, 12 mils minimum thickness at any point.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Probe Cable for use with instruments where shield (if provided) is grounded.