UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            1
                        
                            Page
                            1555
                        
                            Issued:1972-05-19
                    
                            Revised:2011-09-15
                    
                            Style
                            1555
                        
                            Single-conductor cable using non-integral jacket
                    
			Rating80 deg C, 300 Vac (Jacket), Horizontal Flame.
		
			Conductor29 AWG - 20 AWG, solid or stranded, having a minimum 40% conductivity.
		
			InsulationExtruded PE, 15 mils minimum average thickness, 13 mils minimum thickness at any point.
		
			AssemblyA spiral wrap of polyethylene thread with 25 mils nominal in diameter and approximately 0.375 in. between turns shall be applied over the conductor. This assembly shall be enclosed with a polyethylene tube having an approximate 15 mil wall.
		
			CoveringOptional. An extruded nylon covering, 3 mils nominal thickness, 2 mils minimum thickness at any point may be applied over the PE insulation tube.
		
			ShieldOptional.
		
			JacketExtruded PVC, 20 mils minimum average thickness, 16 mils minimum thickness at any point.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of electronic equipment where the jacket is exposed to a maximum operating potential of 300 volts.
		
                UL and the UL Logo are trademarks of UL LLC © 2025

Subj.758	Section 1	Page 1555	Issued:1972-05-19
			Revised:2011-09-15


Rating	80 deg C, 300 Vac (Jacket), Horizontal Flame.

Conductor	29 AWG - 20 AWG, solid or stranded, having a minimum 40% conductivity.

Insulation	Extruded PE, 15 mils minimum average thickness, 13 mils minimum thickness at any point.

Assembly	A spiral wrap of polyethylene thread with 25 mils nominal in diameter and approximately 0.375 in. between turns shall be applied over the conductor. This assembly shall be enclosed with a polyethylene tube having an approximate 15 mil wall.

Covering	Optional. An extruded nylon covering, 3 mils nominal thickness, 2 mils minimum thickness at any point may be applied over the PE insulation tube.

Shield	Optional.

Jacket	Extruded PVC, 20 mils minimum average thickness, 16 mils minimum thickness at any point.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of electronic equipment where the jacket is exposed to a maximum operating potential of 300 volts.