UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            1
                        
                            Page
                            1590
                        
                            Issued:1973-05-18
                    
                            Revised:2012-07-16
                    
                            Style
                            1590
                        
                            Bonded or laminated flat ribbon cable.
                    
			Rating105 deg C, 90 Vac, Horizontal flame.
		
			ConductorFlat, Bare copper. Width variable from 500-1500 mils. Thickness variable from 8-25 mils.
		
			InsulationNon-extruded, PET, 4 mils min average.
		
			AssemblyConsists of two layers of oriented polyethylene terephthalate tape; each layer backed with a 1 mil polyester adhesive. The first layer of tape, 1 mil thick, is longitudinally applied over the conductor, leaving an approximate 0.0625 inch spacing between the edges of the tape. The second layer of tape, 2 mils thick, is then longitudinally applied over the first layer, approximately centered over the spacing formed by the first tape and leaving an approximate 0.0625 inch spacing between the edges of the tape. Conductors shall be parallel.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring.
		
                UL and the UL Logo are trademarks of UL LLC © 2025

Subj.758	Section 1	Page 1590	Issued:1973-05-18
			Revised:2012-07-16


Rating	105 deg C, 90 Vac, Horizontal flame.

Conductor	Flat, Bare copper. Width variable from 500-1500 mils. Thickness variable from 8-25 mils.

Insulation	Non-extruded, PET, 4 mils min average.

Assembly	Consists of two layers of oriented polyethylene terephthalate tape; each layer backed with a 1 mil polyester adhesive. The first layer of tape, 1 mil thick, is longitudinally applied over the conductor, leaving an approximate 0.0625 inch spacing between the edges of the tape. The second layer of tape, 2 mils thick, is then longitudinally applied over the first layer, approximately centered over the spacing formed by the first tape and leaving an approximate 0.0625 inch spacing between the edges of the tape. Conductors shall be parallel.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring.