UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            1
                        
                            Page
                            1791
                        
                            Issued:1979-05-24
                    
                            Revised:2011-10-18
                    
                            Style
                            1791
                        
                            Single conductor with extruded insulation.
                    
			Rating105 deg C, 30 Vac, Horizontal flame.
		
			Conductor4 AWG - 750 kcmil consisting of 36-20 AWG strands, tinned or bare braided copper.
		
			InsulationInner layer - TFE Tape - Min 50 percent overlap, 7 mils minimum thickness at any point. May be heat treated.; Outer Layer - Neoprene Tape - Min 50 percent overlap 20 mils minimum thickness at any point. May be heat treated.
		
			CoveringNylon braid.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseGround strap lead wire for the internal wiring of electronic equipment where the acceptability of the combination is to be determined by Underwriters Laboratories Inc., Class 2 or 3 circuits only.
		
                UL and the UL Logo are trademarks of UL LLC © 2025

Subj.758	Section 1	Page 1791	Issued:1979-05-24
			Revised:2011-10-18


Rating	105 deg C, 30 Vac, Horizontal flame.

Conductor	4 AWG - 750 kcmil consisting of 36-20 AWG strands, tinned or bare braided copper.

Insulation	Inner layer - TFE Tape - Min 50 percent overlap, 7 mils minimum thickness at any point. May be heat treated.; Outer Layer - Neoprene Tape - Min 50 percent overlap 20 mils minimum thickness at any point. May be heat treated.

Covering	Nylon braid.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Ground strap lead wire for the internal wiring of electronic equipment where the acceptability of the combination is to be determined by Underwriters Laboratories Inc., Class 2 or 3 circuits only.