UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            2027
                        
                            Issued:1959-05-01
                    
                            Revised:2011-08-04
                    
                            Style
                            2027
                        
                            Parallel cable with extruded integral insulation and jacket.
                    
			Rating80 deg C, 300 Vac, FT-2 flame, Optional - 60 or 80 deg C Oil.
		
			ConductorThree No. 14, 12 or 10 AWG consisting of No. 30 AWG or smaller strands.
		
			InsulationIntegral with Jacket. Same as for Type SPT-3, PVC, 80 mils minimum average thickness, 72 mils minimum at any point.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			Usenternal wiring of room cooler units where ripped not more than three inches and where exposed to temperatures not exceeding 80 C; or Internal Wiring of Remote Outdoor Condensing units for Domestic Cooling systems where exposed to temperatures not exceeding 80 C. Either marking may also add where applicable dependent upon the compound use: and where exposed to oil at a temperature not exceeding (60 C or 80 C; 	whichever is applicable). Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 2	Page 2027	Issued:1959-05-01
			Revised:2011-08-04


Rating	80 deg C, 300 Vac, FT-2 flame, Optional - 60 or 80 deg C Oil.

Conductor	Three No. 14, 12 or 10 AWG consisting of No. 30 AWG or smaller strands.

Insulation	Integral with Jacket. Same as for Type SPT-3, PVC, 80 mils minimum average thickness, 72 mils minimum at any point.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	nternal wiring of room cooler units where ripped not more than three inches and where exposed to temperatures not exceeding 80 C; or Internal Wiring of Remote Outdoor Condensing units for Domestic Cooling systems where exposed to temperatures not exceeding 80 C. Either marking may also add where applicable dependent upon the compound use: and where exposed to oil at a temperature not exceeding (60 C or 80 C; whichever is applicable). Polarity identification may be omitted.