UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            20528
                        
                            Issued:1986-03-25
                    
                            Revised:2012-07-20
                    
                            Style
                            20528
                        
                            Flat Bonded or Laminated Ribbon Cable
                    
			Rating105 deg C, 30 Vac, Horizontal flame.
		
			Conductor36 AWG - 20 AWG solid or stranded round.
		
			InsulationNon-extruded PVC, 3 mils min average, 2 mils min at any point.
		
			AssemblyTwo to 150 insulated singles or twisted pair or triads laid parallel in one plane, retained by heat or film melt bonded section at random intervals up 2 to 100 in. apart, or along the complete length of cable, with or without PVC bands on one side of the cables in between the heat or film melt bonded sections. Width of heat or film melt bonded sections min 1 inch. Manufacturer shall maintain a record of all singles used in each cable. PVC film or polyester/PVC laminated film may be heat bonded on one or both sides of the cable.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of Class 2 circuits.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 2	Page 20528	Issued:1986-03-25
			Revised:2012-07-20


Rating	105 deg C, 30 Vac, Horizontal flame.

Conductor	36 AWG - 20 AWG solid or stranded round.

Insulation	Non-extruded PVC, 3 mils min average, 2 mils min at any point.

Assembly	Two to 150 insulated singles or twisted pair or triads laid parallel in one plane, retained by heat or film melt bonded section at random intervals up 2 to 100 in. apart, or along the complete length of cable, with or without PVC bands on one side of the cables in between the heat or film melt bonded sections. Width of heat or film melt bonded sections min 1 inch. Manufacturer shall maintain a record of all singles used in each cable. PVC film or polyester/PVC laminated film may be heat bonded on one or both sides of the cable.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of Class 2 circuits.