UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            20592
                        
                            Issued:1988-08-05
                    
                            Revised:2012-05-09
                    
                            Style
                            20592
                        
                            Multiconductor cable with optional extruded non-integral covering.
                    
			Rating250 deg C, 600 Vac, Horizontal flame.
		
			Conductor18 AWG - 10 AWG stranded.
		
			InsulationPFA, Inner Insulation - 15 mils minimum average, 12 mils minimum at any point. Web not specified; Outer Insulation - 20 mils minimum average, 16 mils minimum at any point.
		
			AssemblyTwo conductors, same as type SPT-1. The assembly is prepared for the spiral wound heating element by carefully removing the insulation along the length so as to bare the conductor for approx 0.5 in widths at periodic intervals. The resistance wire is then carefully wound the length of the core and may be soldered to the exposed conductor. By varying the distance between contacts with the conductors, the number of turns per inch of resistance wire and the AWG size (resistance) of the spirally wound wire, different wattages per foot per service voltage can be obtained. Insulation is built with an Inner layer, heating element, and Outer layer, optional shield, and optional covering.
		
			ShieldOptional.
		
			CoveringOptional - PFA, 13 mils minimum at any point.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UsePipe heating cable where the acceptability of the combination is to be determined by Underwriters Laboratories Inc.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 2	Page 20592	Issued:1988-08-05
			Revised:2012-05-09


Rating	250 deg C, 600 Vac, Horizontal flame.

Conductor	18 AWG - 10 AWG stranded.

Insulation	PFA, Inner Insulation - 15 mils minimum average, 12 mils minimum at any point. Web not specified; Outer Insulation - 20 mils minimum average, 16 mils minimum at any point.

Assembly	Two conductors, same as type SPT-1. The assembly is prepared for the spiral wound heating element by carefully removing the insulation along the length so as to bare the conductor for approx 0.5 in widths at periodic intervals. The resistance wire is then carefully wound the length of the core and may be soldered to the exposed conductor. By varying the distance between contacts with the conductors, the number of turns per inch of resistance wire and the AWG size (resistance) of the spirally wound wire, different wattages per foot per service voltage can be obtained. Insulation is built with an Inner layer, heating element, and Outer layer, optional shield, and optional covering.

Shield	Optional.

Covering	Optional - PFA, 13 mils minimum at any point.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Pipe heating cable where the acceptability of the combination is to be determined by Underwriters Laboratories Inc.