UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            21594
                        
                            Issued:2008-06-20
                    
                            Revised:2012-04-18
                    
                            Style
                            21594
                        
                            Multople-conductor cable using non-integral jacket
                    
			Rating90 deg C, 300 Vac.
		
			Conductor36 AWG - 20 AWG min. solid or stranded round, tinned or bare copper.
		
			InsulationETFE, 9 mils min average, 8 mils min at any point
		
			Assembly2-6 individually insulated conductors or groups of conductors cabled together, with an optional mylar tape binder, into a round cable.
		
			ShieldBraid (80 percent min coverage tinned or bare copper or stainless steel) or Aluminum polyester tape (min 25% overlap, 1.5 mils min thickness, with drain wire) over the individual or groups of conductors.
		
			CoveringHDPE, 15 mils minimum average thickness, 13 mils minimum thickness at any point.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseFor Further Processing as Resistance Heater Wire where the acceptability has been determined by Underwriters Laboratories Inc.

                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 2	Page 21594	Issued:2008-06-20
			Revised:2012-04-18


Rating	90 deg C, 300 Vac.

Conductor	36 AWG - 20 AWG min. solid or stranded round, tinned or bare copper.

Insulation	ETFE, 9 mils min average, 8 mils min at any point

Assembly	2-6 individually insulated conductors or groups of conductors cabled together, with an optional mylar tape binder, into a round cable.

Shield	Braid (80 percent min coverage tinned or bare copper or stainless steel) or Aluminum polyester tape (min 25% overlap, 1.5 mils min thickness, with drain wire) over the individual or groups of conductors.

Covering	HDPE, 15 mils minimum average thickness, 13 mils minimum thickness at any point.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	For Further Processing as Resistance Heater Wire where the acceptability has been determined by Underwriters Laboratories Inc.