UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            21918
                        
                            Issued:2013-08-08
                    
                            Revised:New
                    
                            Style
                            21918
                        
                            Multiple Conductor Cable with Extruded Non-integral Jacket.
                    
			Rating125 deg C, 300 Vac, Cable Flame, Optional - Sunlight Res.
		
			InsulationLabeled or complying with manufacturer's AWM Procedure. The designations of all styles of individual conductors used in making up the cable assembly shall be available
		
			AssemblyTwo or more individually insulated conductors or groups of insulated conductors cabled together to form a round cable. A flat or oval cable may also be constructed with not more than three rows of single conductors or groups of conductors. The length of lay of the twisted conductors or groups is not specified. Fillers may be used in a cable but are not required. A barrier layer, if employed, may be a fibrous wrap serving, or braid; paper; nylon; oriented polyethylene terephthalate; or thermoplastic-tape wrap. Such a barrier layer would serve to protect the cable during further processing and would be applied immediately over the twisted assembly of individual conductors or groups of conductors.
		
			ShieldRequired.
		
			JacketExtruded TPE - See Facing Page for Compound Designation.
		
			Diameter of Cable under Jacket in inchesmils minimum averagemils minimum at any point
		
			0.700 or less3024
		
			0.701 - 1.0004536
		
			1.001 - 1.5006048
		
			1.501 - 2.5008064
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseExternal Wiring.
		
                UL and the UL Logo are trademarks of UL LLC © 2024


Rating	125 deg C, 300 Vac, Cable Flame, Optional - Sunlight Res.

Insulation	Labeled or complying with manufacturer's AWM Procedure. The designations of all styles of individual conductors used in making up the cable assembly shall be available

Assembly	Two or more individually insulated conductors or groups of insulated conductors cabled together to form a round cable. A flat or oval cable may also be constructed with not more than three rows of single conductors or groups of conductors. The length of lay of the twisted conductors or groups is not specified. Fillers may be used in a cable but are not required. A barrier layer, if employed, may be a fibrous wrap serving, or braid; paper; nylon; oriented polyethylene terephthalate; or thermoplastic-tape wrap. Such a barrier layer would serve to protect the cable during further processing and would be applied immediately over the twisted assembly of individual conductors or groups of conductors.

Shield	Required.

Jacket	Extruded TPE - See Facing Page for Compound Designation.
	Diameter of Cable under Jacket in inches	mils minimum average	mils minimum at any point
	0.700 or less	30	24
	0.701 - 1.000	45	36
	1.001 - 1.500	60	48
	1.501 - 2.500	80	64

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	External Wiring.