UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            21930
                        
                            Issued:2013-08-30
                    
                            Revised:New
                    
                            Style
                            21930
                        
                            Bonded flat ribbon cable with other-than-extruded covering.
                    
			Rating80 deg C, 30 Vac, Horizontal flame.
		
			Conductor40 AWG - 20 AWG, solid or stranded.
		
			InsulationExtruded HDPE, 4 mils minimum average thickness, 3 mils minimum thickness at any point before and after separation.
		
			Assembly6 - 66C insulated conductors laid parallel by thermal bonding with 4 - 34 conductive HDPE shield members which are extruded over each metal strength member.
		
			ShieldAL part of AL/PET tape and extruded conductive HDPE members with drain wires.
		
			CoveringAL/PET tape, 1.0 mil minimum thickness bonded with EVA adhesive, 0.1 mils minimum thickness, wrapped with minimum 5% overlap. Overlap portion is covered by PET tape, 0.5 mils minimum thickness and 160 mils minimum width, bonded with Polyester adhesive, 0.1 mils minimum thickness.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of Class 2 circuit.
		
                UL and the UL Logo are trademarks of UL LLC © 2025


Rating	80 deg C, 30 Vac, Horizontal flame.

Conductor	40 AWG - 20 AWG, solid or stranded.

Insulation	Extruded HDPE, 4 mils minimum average thickness, 3 mils minimum thickness at any point before and after separation.

Assembly	6 - 66C insulated conductors laid parallel by thermal bonding with 4 - 34 conductive HDPE shield members which are extruded over each metal strength member.

Shield	AL part of AL/PET tape and extruded conductive HDPE members with drain wires.

Covering	AL/PET tape, 1.0 mil minimum thickness bonded with EVA adhesive, 0.1 mils minimum thickness, wrapped with minimum 5% overlap. Overlap portion is covered by PET tape, 0.5 mils minimum thickness and 160 mils minimum width, bonded with Polyester adhesive, 0.1 mils minimum thickness.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of Class 2 circuit.