UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            21931
                        
                            Issued:2013-08-30
                    
                            Revised:New
                    
                            Style
                            21931
                        
                            Bonded flat ribbon cable using non-integral jacket.
                    
			Rating80 deg C, 30 Vac, Cable flame.
		
			Conductor40 AWG - 20 AWG, solid or stranded.
		
			InsulationExtruded HDPE, 4 mils minimum average thickness, 3 mils minimum thickness at any point before and after separation.
		
			Assembly6 - 66C insulated conductors laid parallel by thermal bonding with 4 - 34 conductive HDPE shield members which are extruded over each metal strength member.
		
			ShieldAL part of AL/PET tape and extruded conductive HDPE members with drain wires.
		
			CoveringAL/PET tape bonded with EVA adhesive, wrapped with overlap. Overlap portion is covered by PET tape bonded with Polyester adhesive.
		
			JacketExtruded PVC.
		
			Diameter of core assembly under jacketMinimum average thicknessMinimum thickness at any point
		
			0.400 inch or less24 mils20 mils
		
			0.401-0.700 inch30 mils24 mils
		
			0.701-1.500 inch45 mils36 mils
		
			1.501-2.500 inch60 mils48 mils
		
			The equivalent diameter of a flat assembly is to be calculated as 1.1284 x (TW)1/2 in which T is the thickness of the assembly under the jacket and W is the width of the assembly under the jacket.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseExternal wiring.
		
                UL and the UL Logo are trademarks of UL LLC © 2025


Rating	80 deg C, 30 Vac, Cable flame.

Conductor	40 AWG - 20 AWG, solid or stranded.

Insulation	Extruded HDPE, 4 mils minimum average thickness, 3 mils minimum thickness at any point before and after separation.

Assembly	6 - 66C insulated conductors laid parallel by thermal bonding with 4 - 34 conductive HDPE shield members which are extruded over each metal strength member.

Shield	AL part of AL/PET tape and extruded conductive HDPE members with drain wires.

Covering	AL/PET tape bonded with EVA adhesive, wrapped with overlap. Overlap portion is covered by PET tape bonded with Polyester adhesive.

Jacket	Extruded PVC.
	Diameter of core assembly under jacket	Minimum average thickness	Minimum thickness at any point
	0.400 inch or less	24 mils	20 mils
	0.401-0.700 inch	30 mils	24 mils
	0.701-1.500 inch	45 mils	36 mils
	1.501-2.500 inch	60 mils	48 mils
	The equivalent diameter of a flat assembly is to be calculated as 1.1284 x (TW)1/2 in which T is the thickness of the assembly under the jacket and W is the width of the assembly under the jacket.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	External wiring.