UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            2232
                        
                            Issued:1959-05-01
                    
                            Revised:2011-09-28
                    
                            Style
                            2232
                        
                            Parallel cable with extruded insulation and jacket.
                    
			Rating90 deg C, 600 Vac, FT2 flame. Optional - Oil Resistant 60 deg C or 80 deg C.
		
			ConductorNo. 14, 12 or 10 AWG consisting of No. 30 AWG or smaller tinned or bare copper.
		
			InsulationIntegral with Jacket. Extruded PVC, 70 mils min average, 63 mils minimum at any point.
		
			AssemblyFour conductors, same as type SPT-3. except for a nominal 80 mil wall, the following minimum (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.141 in., Wall after rip: 0.058 in..
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of room cooler units where exposed to temperatures not exceeding 90 deg C; or Internal wiring of room cooler units where exposed to temperatures not exceeding 90 deg C and where exposed to oil at a temperature not exceeding (60 deg C or 80 deg C; whichever is applicable). Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 2	Page 2232	Issued:1959-05-01
			Revised:2011-09-28


Rating	90 deg C, 600 Vac, FT2 flame. Optional - Oil Resistant 60 deg C or 80 deg C.

Conductor	No. 14, 12 or 10 AWG consisting of No. 30 AWG or smaller tinned or bare copper.

Insulation	Integral with Jacket. Extruded PVC, 70 mils min average, 63 mils minimum at any point.

Assembly	Four conductors, same as type SPT-3. except for a nominal 80 mil wall, the following minimum (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.141 in., Wall after rip: 0.058 in..

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of room cooler units where exposed to temperatures not exceeding 90 deg C; or Internal wiring of room cooler units where exposed to temperatures not exceeding 90 deg C and where exposed to oil at a temperature not exceeding (60 deg C or 80 deg C; whichever is applicable). Polarity identification may be omitted.