UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            2327
                        
                            Issued:1961-06-15
                    
                            Revised:2012-03-22
                    
                            Style
                            2327
                        
                            Parallel cable with extruded integral insulation and jacket
                    
			Rating105 deg C, 600 Vac, FT-2 flame, Moisture Res 60 deg C
		
			Conductor14, 12, or 10 AWG consisting of 30 AWG or smaller tinned or bare copper.
		
			InsulationIntegral with Jacket. PVC, 70 mils min average, 63 mils minimum at any point.
		
			AssemblyTwo conductors.Same as for Type SPT-3, except for a nominal 80 mil wall, the following minimum (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.141 in., Wall after rip: 0.058 in..
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal Wiring of Electric Refrigerating Equipment or Room Air Conditioners or Room Cooler Units where exposed to temperatures not exceeding 105 deg C; or Internal Wiring of Electric Refrigeration Equipment or Room Air Conditioners of Room Cooler Units where exposed to temperatures not exceeding 105 deg C or where exposed to oil at a temperature not exceeding (60 deg C or 80 deg C, whichever is applicable); Moisture Resistant 60 deg C. Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 2	Page 2327	Issued:1961-06-15
			Revised:2012-03-22


Rating	105 deg C, 600 Vac, FT-2 flame, Moisture Res 60 deg C

Conductor	14, 12, or 10 AWG consisting of 30 AWG or smaller tinned or bare copper.

Insulation	Integral with Jacket. PVC, 70 mils min average, 63 mils minimum at any point.

Assembly	Two conductors.Same as for Type SPT-3, except for a nominal 80 mil wall, the following minimum (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.141 in., Wall after rip: 0.058 in..

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal Wiring of Electric Refrigerating Equipment or Room Air Conditioners or Room Cooler Units where exposed to temperatures not exceeding 105 deg C; or Internal Wiring of Electric Refrigeration Equipment or Room Air Conditioners of Room Cooler Units where exposed to temperatures not exceeding 105 deg C or where exposed to oil at a temperature not exceeding (60 deg C or 80 deg C, whichever is applicable); Moisture Resistant 60 deg C. Polarity identification may be omitted.