UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            2
                        
                            Page
                            2559
                        
                            Issued:1972-01-05
                    
                            Revised:2012-04-13
                    
                            Style
                            2559
                        
                            Multiple-conductor cable using non-integral jacket.
                    
			Rating60 deg C, 30 Vac, Horizontal flame.
		
			Conductor29 AWG - 20 AWG, copper, copper-clad steel, copper alloy, bare, tinned or silver-coated, having a minimum of 40 per cent conductivity.

			InsulationOver the conductor shall be applied a spiral wrap of flame-retardant polyethylene thread nominally 15 mils in diameter, approximately 1/2 in. between turns. This assembly shall be enclosed with a flame-retardant polyethylene tube having an approximately 15 mil wall.

			ShieldA shield over each tube shall consist of a wrap of aluminum faced "Mylar" tape with a drain wire applied under the shield.

			AssemblyCable consists of two to nine conductors, laid flat to form a ribbon type cable with a maximum width of one inch.

			JacketExtruded PVC, 47 mils minimum average thicknes, 43 mils minimum at any point.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of electronic equipment.
		
                UL and the UL Logo are trademarks of UL LLC © 2025

Subj.758	Section 2	Page 2559	Issued:1972-01-05
			Revised:2012-04-13


Rating	60 deg C, 30 Vac, Horizontal flame.

Conductor	29 AWG - 20 AWG, copper, copper-clad steel, copper alloy, bare, tinned or silver-coated, having a minimum of 40 per cent conductivity.

Insulation	Over the conductor shall be applied a spiral wrap of flame-retardant polyethylene thread nominally 15 mils in diameter, approximately 1/2 in. between turns. This assembly shall be enclosed with a flame-retardant polyethylene tube having an approximately 15 mil wall.

Shield	A shield over each tube shall consist of a wrap of aluminum faced "Mylar" tape with a drain wire applied under the shield.

Assembly	Cable consists of two to nine conductors, laid flat to form a ribbon type cable with a maximum width of one inch.

Jacket	Extruded PVC, 47 mils minimum average thicknes, 43 mils minimum at any point.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of electronic equipment.