UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            4
                        
                            Page
                            4037
                        
                            Issued:1959-05-01
                    
                            Revised:2012-03-27
                    
                            Style
                            4037
                        
                            Parallel Cable with Extruded Integral Insulation and Jacket
                    
			Rating60 deg C, 300 Vac, Horizontal flame.
		
			Conductor14 AWG - 10 AWG consisting of No. 30 AWG or smaller solid or stranded round, tinned or bare.
		
			InsulationSRB/NR, integral with Jacket, 80 mils minimum average thickness, 72 mils minimum thickness at any point.
		
			AssemblyTwo conductors, parallel construction, same as Type SP with the following (pin gauge) dimensions: Wall thickness: 0.070 inches, Web thickness: 0.109 inches, Wall after rip: 0.043 inches.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of room cooler units where ripped not more than three inches unless installed in a separate metal enclosure. Polarity identification may be ommited.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 4	Page 4037	Issued:1959-05-01
			Revised:2012-03-27


Rating	60 deg C, 300 Vac, Horizontal flame.

Conductor	14 AWG - 10 AWG consisting of No. 30 AWG or smaller solid or stranded round, tinned or bare.

Insulation	SRB/NR, integral with Jacket, 80 mils minimum average thickness, 72 mils minimum thickness at any point.

Assembly	Two conductors, parallel construction, same as Type SP with the following (pin gauge) dimensions: Wall thickness: 0.070 inches, Web thickness: 0.109 inches, Wall after rip: 0.043 inches.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of room cooler units where ripped not more than three inches unless installed in a separate metal enclosure. Polarity identification may be ommited.