UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            4
                        
                            Page
                            4038
                        
                            Issued:1959-05-01
                    
                            Revised:2012-05-04
                    
                            Style
                            4038
                        
                            Parallel Cable with Extruded Integral Insulation and Jacket
                    
			Rating75 deg C, 300 Vac, Horizontal flame.
		
			Conductor14 AWG - 10 AWG consisting of No. 30 AWG or smaller solid or stranded round, tinned or bare.
		
			InsulationExtruded NR - integral with Jacket, 80 mils minimum average thickness, 72 mils minimum thickness at any point.
		
			AssemblyTwo conductor, same as type SP Cord with a nominal 60 mils wall tickness and the following (pin gauge) dimensions:
		
			Wall thickness:70 mils
		
			Web thickness:109 mils
		
			Wall after rip:43 mils
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal Wiring of Room Cooler Units where ripped not more than three inches, unless installed in a separate metal enclosure. Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 4	Page 4038	Issued:1959-05-01
			Revised:2012-05-04


Rating	75 deg C, 300 Vac, Horizontal flame.

Conductor	14 AWG - 10 AWG consisting of No. 30 AWG or smaller solid or stranded round, tinned or bare.

Insulation	Extruded NR - integral with Jacket, 80 mils minimum average thickness, 72 mils minimum thickness at any point.

Assembly	Two conductor, same as type SP Cord with a nominal 60 mils wall tickness and the following (pin gauge) dimensions:
	Wall thickness:	70 mils
	Web thickness:	109 mils
	Wall after rip:	43 mils

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal Wiring of Room Cooler Units where ripped not more than three inches, unless installed in a separate metal enclosure. Polarity identification may be omitted.