UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            4
                        
                            Page
                            4041
                        
                            Issued:1959-05-01
                    
                            Revised:2012-04-12
                    
                            Style
                            4041
                        
                            Style SP Cord.
                    
			Rating60 deg C, 300 Vac, Horizontal flame.
		
			Conductor14 AWG - 10 AWG consisting of No. 30 AWG or smaller solid or stranded round, tinned or bare copper.
		
			InsulationIntegral with Jacket. Extruded SRB/NR, 80 mils min average, 72 mils minimum at any point.
		
			AssemblyThree conductor, same as type SP with a nominal 80 mils wall the following (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.109 in., Wall after rip: 0.043 in.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal Wiring of Room Cooler Units where ripped not more than three inches unless installed in a separate metal enclosure. Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 4	Page 4041	Issued:1959-05-01
			Revised:2012-04-12


Rating	60 deg C, 300 Vac, Horizontal flame.

Conductor	14 AWG - 10 AWG consisting of No. 30 AWG or smaller solid or stranded round, tinned or bare copper.

Insulation	Integral with Jacket. Extruded SRB/NR, 80 mils min average, 72 mils minimum at any point.

Assembly	Three conductor, same as type SP with a nominal 80 mils wall the following (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.109 in., Wall after rip: 0.043 in.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal Wiring of Room Cooler Units where ripped not more than three inches unless installed in a separate metal enclosure. Polarity identification may be omitted.