UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            4
                        
                            Page
                            4114
                        
                            Issued:1959-05-01
                    
                            Revised:2011-11-29
                    
                            Style
                            4114
                        
                            Parallel Cord
                    
			Rating60 deg C, 300 Vac, Horizontal flame.
		
			Conductor18 AWG - 16 AWG consisting of No. 30 AWG or smaller stranded, tinned or bare copper.
		
			InsulationIntegral with Jacket. SRB/NR, 60 mils min average, 54 mils minimum at any point.
		
			AssemblyFour conductors, same as type SP Cord.
		
			JacketWith a nominal 60 mils wall rubber and the following (pin gauge) dimensions: Wall thickness: 0.058 in. Web thickness: 0.078 in. Wall after rip: 0.028 in.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of electric refrigerators where ripped not more than three inches unless installed in a separate metal enclosure. Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 4	Page 4114	Issued:1959-05-01
			Revised:2011-11-29


Rating	60 deg C, 300 Vac, Horizontal flame.

Conductor	18 AWG - 16 AWG consisting of No. 30 AWG or smaller stranded, tinned or bare copper.

Insulation	Integral with Jacket. SRB/NR, 60 mils min average, 54 mils minimum at any point.

Assembly	Four conductors, same as type SP Cord.

Jacket	With a nominal 60 mils wall rubber and the following (pin gauge) dimensions: Wall thickness: 0.058 in. Web thickness: 0.078 in. Wall after rip: 0.028 in.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of electric refrigerators where ripped not more than three inches unless installed in a separate metal enclosure. Polarity identification may be omitted.