UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            4
                        
                            Page
                            4394
                        
                            Issued:1989-06-01
                    
                            Revised:2012-07-20
                    
                            Style
                            4394
                        
                            Parallel cable with extruded integral insulation and jacket.
                    
			Rating125 deg C, 600 Vac.
		
			Conductor14 AWG - 10 AWG consisting of 30 AWG or smaller copper strands only.
		
			InsulationIntegral with Jacket. EP, nominal 80 mils wall of 28 EP (see facing page for compound) and the following (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.109 in., Wall after rip: 0.043 in.
		
			AssemblyTwo, three, or four conductors, same as type SP Cord.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseInternal wiring of electric refrigerators or other equipment where ripped not more than 3 in unless installed in a separate metal enclosure; or for use only in the wiring of butter conditioners where exposed at the door hinge or as motor lead wire in outdoor condensing units for domestic cooling systems where the acceptability has been determined by Underwriters Laboratories Inc. Polarity identification may be omitted.
		
                UL and the UL Logo are trademarks of UL LLC © 2024

Subj.758	Section 4	Page 4394	Issued:1989-06-01
			Revised:2012-07-20


Rating	125 deg C, 600 Vac.

Conductor	14 AWG - 10 AWG consisting of 30 AWG or smaller copper strands only.

Insulation	Integral with Jacket. EP, nominal 80 mils wall of 28 EP (see facing page for compound) and the following (pin gauge) dimensions: Wall thickness: 0.070 in., Web thickness: 0.109 in., Wall after rip: 0.043 in.

Assembly	Two, three, or four conductors, same as type SP Cord.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Internal wiring of electric refrigerators or other equipment where ripped not more than 3 in unless installed in a separate metal enclosure; or for use only in the wiring of butter conditioners where exposed at the door hinge or as motor lead wire in outdoor condensing units for domestic cooling systems where the acceptability has been determined by Underwriters Laboratories Inc. Polarity identification may be omitted.