UL iQ™ for Appliance Wiring Materials

	
                            APPLIANCE WIRING MATERIAL
                        
                            Subj.758
                        
                            Section
                            5
                        
                            Page
                            5189
                        
                            Issued:1981-07-24
                    
                            Revised:2020-04-27
                    
                            Style
                            5189
                        
                            Single-conductor cable using non-extruded covering and other-than-extruded insulation.
                    
			Rating105 deg C, 600 Vac.
		
			Conductor20 AWG - 4 AWG, 38-30 AWG stranding, Length of Lay per requirements for type ST Cord, May employ rope lay stranding in all sizes per UL 62 except the maximum lay of members shall be 1 inch for 20 and 19 AWG sizes, 2 inches for 18-11 AWG, 2 1/2 inches for 10 and 9 AWG.
		
			InsulationNon-extruded PETP tape, minimum 0.8 mil thickness, applied over the conductor with halt lap.
		
			Inner CoveringNon-extruded PETP Yarn. One layer spiral wrapped or braid over insulation.
		
			Outer CoveringNon-extruded PETP Yarn. One layer braided over above covering.
		
			StandardAppliance Wiring Material UL 758.
		
			MarkingGeneral.
		
			UseLead wire within Hermetic Motors where the acceptability of the combination is to be determined by Underwriters Laboratories, Inc.
		
                UL and the UL Logo are trademarks of UL LLC © 2025

Subj.758	Section 5	Page 5189	Issued:1981-07-24
			Revised:2020-04-27


Rating	105 deg C, 600 Vac.

Conductor	20 AWG - 4 AWG, 38-30 AWG stranding, Length of Lay per requirements for type ST Cord, May employ rope lay stranding in all sizes per UL 62 except the maximum lay of members shall be 1 inch for 20 and 19 AWG sizes, 2 inches for 18-11 AWG, 2 1/2 inches for 10 and 9 AWG.

Insulation	Non-extruded PETP tape, minimum 0.8 mil thickness, applied over the conductor with halt lap.

Inner Covering	Non-extruded PETP Yarn. One layer spiral wrapped or braid over insulation.

Outer Covering	Non-extruded PETP Yarn. One layer braided over above covering.

Standard	Appliance Wiring Material UL 758.

Marking	General.

Use	Lead wire within Hermetic Motors where the acceptability of the combination is to be determined by Underwriters Laboratories, Inc.